The query has to be between 2 and 50 characters
Products in this catalogue
z 3 % 2 & ; i g & § g = z COLOUR CUE .~ ADD VERVE AND PERSONALITY TO YOUR HOME BY CREATING THESE ONE-OF-A-KIND PIECES Photography BELINDA MERRIE Projects and styling SAM VAN KAN MARBLE-LOOK CUBE TABLE Upcycle a small square table by cladding MDF sheets in marble- pattern vinyl film. Our table is 450mm high with a 55Omm-square top. Adjust the MDF and vinyl measurements so they cover the sides and top of your table. 3 Use the same method to cover each MDF panel. Trim the corners diagonally and fold the excess around to the back. i & g a a Tools & materials ™ Safety equipment (mask, eye and ear protection) ™ Tape measure and pencil ® Circular saw with straightedge @ Scissors ™ Grout squeegee @ Two quick-grip clamps ™ Caulking tool ™ Cloth 1 Two sheets of 1200mm x 600mm x 4.75mm MDF* @ Two rolls of 2000mm x 675mm self-adhesive decor film & Small square timber table = Construction adhesive with applicator ™ Painter's tape ™ Flexible gap filler with applicator 1 Using a circular saw with a straightedge, cut four 5SOmm x 450mm panels from MDF. Using scissors, cut four 650mm x 550mm side pieces and a 650mm x 650mm top piece from self-adhesive decor film. 4 With the table on its side, apply adhesive along the top edge and down the legs. Position a panel, clamping and leaving to dry for half an hour. Repeat with the remaining panels, leaving the cube to dry thoroughly. DOIT HOME PROJECTS ‘i 1 Irwin ‘Quick-Grip’ 30cm bar clamps, $35/ pack of 2, I/N: 5861592. 2 NewDecor 2000mm x 675mm home decor film in White Marble, $32, |/N: 0278747. 3 Selleys ‘Ezi Press No filler, $13.25/170g, I/N: 1210585. Panel’ 1200mm x 600mm x 4.75mm MDF, $8.71, |/N: 0294502". Some products are not available at all Bunnings stores, but may be ordered. 2 Peel the backing from a corner of the top piece of film, centre it on the tabletop and use a grout squeegee to smooth out air bubbles while pulling away the backing. Trim the corners and press down the sides. 5 Apply painter's tape outside the tabletop and panel joints and run a bead of filler along the gaps. Dip a caulking tool in water and run it along the filler for a smooth finish, wiping away excess with a damp cloth. Remove the tape and leave to dry. > ® bunnings |G) bunningsnz | bunnings.co.nz_ 69
| Name | Details |
|---|
