Products in this catalogue
DREAM IT OUTDOOR STYLE ALFRESCO ESSENTIALS TRY YOUR HAND AT THESE DIY GLAMPING PROJECTS a. = Tools & materials ™@ Safety equipment (mask, ear and eye protection) ™ Tape measure and pencil ® Circular saw with straightedge @ Framing square & Drill with 3mm, 2mm, 6mm countersinking and driver bits @ Screwdriver ™ Quick-grip clamps ™ Cloths ™ Combination pliers @ Five 1200mm x 600mm x 12mm plywood sheets* ™ 180-grit abrasive paper with sanding block ® Masking tape @ Exterior adhesive ™@ 8G x 25mm countersunk screws ® Danish oil @ Four 90mm x 60mm loos in butt hinges @ 8G x 12mm and 15mm pan head screws ™@ 1.8mm clock chain ™ Four 7mm screw eye hooks ™ 256mm cabinet handle 1 Two 170mm heavy-duty pull handles ™ Magnetic cupboard catch ™@ Sash fastener 36 bunnings.co.nz | (O) bunningsnz | (®) bunnings CAMPING KITCHEN Inspired by an American ‘chuck box’, this caddy holds all the essentials. We've added handles, hooks and magnets to ensure equipment is secure when travelling 4 Secure the shelf lip to the top shelf from underneath, position in the box, securing the shelf into the dividers and through the sides. At the back, mark lines to secure all the shelves, spacing the screws evenly. Use a cloth to seal all the plywood with two coats of oil, leaving to dry after each. 8 On the front, mark 184mm from the edges and 60mm from the top to pre-drill and secure a 256mm cabinet handle, snapping the supplied screws to fit. Position pull handles ‘on the sides, 185mm from the front and 75mm down, pre-drill through the holes, clamp. packers inside and secure right through with 25mm screws. Tip: Packers allow for longer screws and add strength. 1Cut the plywood according to the cutting list. Tip: For all joints, use a framing square to mark a line for screws on the best face, pre-drill with a 3mm bit and finish with a 6mm countersinking bit. Apply adhesive along raw edges, secure with 25mm screws and clamp while the adhesive dries. & 5 On the lid, mark a line 6mm in from the front edge to secure the lid lip. On the inside of the lid, at the back, mark 60mm in from the side edges to pre-drill and secure hinges with 12mm screws. Position the lid on the box, with the hinges outside the back panel, and secure. 9 Centre a magnetic catch on the underside of the top shelf, with the strike plate on the front, 45mm down, securing with the supplied screws. Centre a sash fastener on the lid lip, with the catch on the front, pre-drill and install 15mm pan head screws with a screwdriver to avoid stripping. Tip: We chose black hardware, spray-painting the pull handles to match. iurthier informibtion. Project and steps photography Sam van Kan Project editing Natasha Dickins “Timbers iiary by region; contact your local stare fi
| Name | Details |
|---|
