Products in this catalogue
Ne 2 Butt the side pieces against 3 Centre the short shelf against Cutting list the back. Mark a line 6mm in the base divider and secure, lm On five sheets of aia 1200mm x 600mm. from the rear edges to secure then position in the box, x 12mm plywood, with screws 20mm, 143mm, securing through the base use the 600mm 255mm and 41imm down and sides. Secure both dividers widths to mark from the top. Mark 33mm to the middle shelf from a 600mm back, up from the base to secure underneath, then position two 512mm sides, the base shelf through the the middle shelf in the box, three 500mm sides. Tip: Use the position of securing into the base divider renee SU1OPs the screws as a shelf guide. and through the sides. and a 50mm shelf lip. Mark a 624mm x 524mm lid, 624mm x 455mm. front and 624mm x 120mm lid lip. On the offcuts, . mark S0O0mm 5 i width for a 300mm oui base divider, two 6 On the inside of the front, 7 Use pliers to cut two 580mm 100mm middle at the base, mark 60mm lengths of chain and open four shelf dividers and in from the side edges to eye hooks with a 2mm gap. 294mm short pre-drill and secure hinges Under the lid and inside the shelf. Cut two . 25 200mm x SOmm with 12mm screws. Position box, 150mm from the front packers. Label the front against the box, and 30mm from the edges, all pieces with with the hinges underneath pre-drill with a 2mm bit, twist masking tape. the base shelf and secure. in the hooks, loop on the chain and press closed. Cut from large to small using a circular saw with a straightedge. Smooth the cuts with 180-grit abrasive paper to remove any * breakout. 5 piece titanium countersink bit set, $15.99, I/N: 0694871. 3 Ozito 165mm. 1200W plunge track saw kit, $349, |/N: 6290615. 4 Pinnacle 25mm x 4mm CSK timber screws in Black, $14.95/pack of 250, I/N: 0201373. 5 Windsor Hardware sash fastener in Black, $36.95, I/N: 0173324. Some products are not available at all Bunnings stores, but may be ordered. Keep in mind... ™ Always wear the recommended safety gear to use power tools. Work in a well-ventilated area and wear a mask when using cutting tools and sanding, = If spray-painting, wear eye protection, a mask and gloves. Work outside or in a well ventilated area. Cover nearby areas with a drop sheet to avoid overspray. = For maximum protection from moisture and UV damage, choose non-structural plywood, stainless-steel hardware and exterior finishes. ™ Enlist a second pair of hands to lift and move the box safely. Box is designed for transport and storage only. It is not heat-safe or flameproof.
| Name | Details |
|---|
