Products in this catalogue
2 Mark the sides 150mm in from the edges and up from the base to drill with a countersinking bit. Install 40mm screws to protrude by 3mm. Pre-drill into dowel endgrain with a 3mm bit, apply adhesive, position it between the sides, with the screws in the holes, and secure. 4 Apply adhesive to the upper edges of the sides, then secure the top through the centre holes with 40mm screws. Use a combination square to check the sides are straight, then hold with 450mm clamps, securing the remaining screws. Wipe away excess adhesive with a damp cloth and leave to dry. ‘ > 6 Sand all over with 180-grit abrasive paper to remove excess filler and round over the cuts to match the factory edges. Wipe away dust with a damp cloth. Apply two coats of water-based varnish with a mini roller, leaving to dry thoroughly after each coat. > @ Keep in mind... ™ Work in a well-ventilated area and wear a mask when using cutting tools and sanding, = When using power tools, always wear the recommended safety gear. 1 If stacking two or more pieces, anchor securely using fixings suitable for your wall type. TTB SurePave -I/N: 3452192 ‘Trade Pack (100 Panels) IN = N: 0106859 d ‘Trade Packs avalabe to order online cor at the Special Orders Desk 4m x Sm - I/N: 0332577 4m x 10m - I/N: 0332578,
| Name | Details |
|---|
